12
EN
13
EN
Wine cabinet layout advice
Your EuroCave wine cabinet is designed to safely hold a maximum number
of bottles. We recommend that you observe the following advice in order
to optimise loading.
•
Ensure that you distribute your bottles as uniformly as possible over the
shelves of your cabinet, in order to distribute the weight over as large
an area as possible.
•
Also ensure that you distribute your bottles uniformly over the height
of the wine cabinet (avoid loading all the bottles at the top or all the
bottles at the bottom).
•
Observe the loading instructions according to the type of storage
equipment your cabinet has, and never stack bottles on a sliding shelf.
•
Fill the cabinet to more than 75% of its capacity to ensure a uniform
temperature.
When using your wine cabinet, never pull out more than one
sliding shelf at a time.
I. Changing the position of a sliding shelf
The shelf in the centre of your cabinet is fixed. It is used as a stiffener and cannot be removed. The other shelves in the cabinet can be moved.
If your sliding shelf is already positioned in your cabinet:
•
Completely unload the sliding shelf.
•
Then remove the sliding shelf by sliding it towards you whilst lifting the front section.
•
Remove the slide guides from the walls, marking off the right guide and the left guide.
•
Then proceed to set up the sliding shelf (see diagrams below).
a.
b.
The latch of the soft close device cannot be latched (left runner).
It is essential to latch it before positioning the sliding shelf on the runners.
Ensure that the latch is positioned towards the front.
If it is not, pull it forwards to latch it.
The number of Main du Sommelier supports on each shelf can be adjusted according to the type of bottles stored (Magnums, Champagne,
Bordeaux...).
5/ LAYOUT – STORAGE
Universal sliding shelf fitted with “New Main du Sommelier” support
Ref: ACMSR (Stained black ash front)
Capacity: 9 traditional Bordeaux
bottles
Capacity: 9 bottles including 7
traditional Bordeaux b 2
magnums
Capacity: 5 magnums
Installing the cabinet with the back to a wall
If you place your cabinet with its back to the wall, install the stop at the top, at the back of your cabinet. It is located in the accessories bag.
Installing the cabinet in a corner
1
Remove the screws located at the back of your cabinet, at the top,
usinga screwdriver.
2
Screw the rear stop using these two same screws.
1
Remove the screws fastening the hinge to the door using a T25
screwdriver.
2
Move forward the hinge attachment by one notch on the right.
3
Replace the screws on this new pivot fixing hole.
T25 (not supplied)
Installing two cabinets side by side
There is no reason why two cabinets cannot be installed side by side.
IV. Different installations
4/ INSTALLING YOUR WINE CABINET
N.B.: If the cabinet is placed in a corner, the door hinge must be fitted so that it does not open more than 90°.
T25 (not supplied)
110°
90°
Summary of Contents for V-ROYALE-L
Page 1: ...User Manual ...
