7
5 - I
NSTALLING YOUR WINE CABINET
-On unpacking you wine cabinet after delivery, check for any obvious exterior damage (dents, malformation, etc.).
- Open the door and check that the inside of the appliance is complete and in good condition (walls, shelves, hinges, control panel, etc.).
- In the event of a problem, contact your dealer.
- Move your wine cabinet to your selected location. This location should:not be a confined space. There should be- allow air flow around the cabinet.
(not placed in a cupboard, etc.)
- away from any heat source
- not too wet (wash room, utility room, bathroom, etc.)
- be on a flat solid floor
- have an electrical power supply (standard 13A plug connected to a 30 mA circuit breaker)
- Never place your wine cabinet in a location liable to flooding.
- Avoid splashing water onto the base of the appliance.
- Place the clay humidity vessel (for 1 and 2-temperature models only), which you will find
inside your cabinet's "accessories" box) in the receptacle provided for it beneath the grid
located at the base of the cabinet (see diagram page 20). When using the vessel for the first
time, please soak it for ten minutes in water, and let it drain.
- Install the drip tray (which you will find inside your cabinet's "accessories" box) on the
compressor support at the back of the cabinet, locating it under the small pipe protruding
from the housing, the lower part of the tank being placed under this pipe (see diagram
opposite).
- Take the power lead (which you will find inside your cabinet's "accessories" box) and connect it to the socket provided
at the rear bottom left of the cabinet.
- Unwind the power supply lead so that it can be accessed and place the appliance leaving a space between 8 and 10 cm
space between the wall and the back of your wine cabinet.
- Place the power supply lead so that it is not in contact with any of the appliance's components.
-
I M P O RTANT - Wait 48 hours befo re switching on to allow the fluids contained in the internal circuits to settle.
- Gently incline the wine cabinet backwards in order to adjust the front feet (screw adjustment) so that your wine cabinet
stands perfectly level (we recommend using a spirit level).
- Remove the protective items located inside your wine cabinet.
- Install the carbon filter, which you will find inside your cabinet's "accessories" box , by placing it in the air circulation hole located inside the cabinet on the
top left hand side (see diagram opposite).
N.B.: when moving your wine cabinet, do not incline it more than 45°,and always
toward side where the power lead is located.
Did you know?
A wine cabinet must be designed in such a way that bottles do not come into contact with the rear wall. In
some circumstances, condensation created on the rear wall can trickle down onto the shelves and damage the
bottle labels. Also, contact with a cold wall can create a frost point which is harmful to the wine.
I - In General
