14
4.2 Installation of hand drilling machine
1.
Measure the collar of the hand drilling machine you want to place in the magnetic drill stand.
The magnetic drill stand is suitable for use with hand drilling machines with Ø 43 mm, Ø 38
mm or Ø 33 mm collar.
2.
Loosen the bolt on front of the tool holder slightly. Do not remove the bolt.
3.
Prepare the tool holder for the hand drilling machine:
a.
Ø 43 mm collar:
no insert
b.
Ø 38 mm collar:
insert only the 1 piece adapter ring (outer Ø 43 mm)
c.
Ø 33 mm collar:
insert only the 2 piece adapter ring (outer Ø 43 mm)
4.
Place the hand drilling machine in the tool holder as deep as the collar on the hand drilling
machine allows. Make sure only the collar and no other parts are placed inside the tool
holder (image 3-1)
5.
Tighten the bolt on front of the tool holder. Do not overtighten.
6.
Check if the rated Voltage and Hertz of the fitted hand drilling machine matches with the
magnetic drill stand.
7.
Check if the power plug of the fitted hand drilling machine corresponds with the power
socket on the back of the magnetic drill stand (image 3-2)
8.
Place the power plug of the fitted hand drilling machine in the power socket of the magnetic
drilling stand correctly and tightly.
9.
Make sure the power cable of the hand drilling machine stays clear of the general drilling
area.
[image 3-1]
[image 3-2]
www.fnglob.pl
