www.euroboor.com
21
4.2 Working with the machine
1)
Set the speed adjustment wheel to the highest speed.
2)
Switch the machine on. Do not move the machine towards the workpiece until full speed has
been reached.
3)
Hold the machine in such a way that the support deck is flat on the workpiece.
4)
Slightly push the machine against the workpiece and let the machine do its work. Lower the
speed of the machine if necessary (depending on the material of the workpiece) and slowly
move the machine in the correct direction to make the bevel. Avoid collisions during
processing.
WARNING:
From the users’ perspective, the milling head is spinning clockwise. T
he
machine must always be guided from left to right (conventional up milling), or clockwise
when processing inside bevels.
5)
Once the bevelling pass is completed, take the machine from the workpiece.
WARNING:
Do not bevel more than 2 mm depth per pass. If more depth is needed, adjust
the bevelling depth in steps of maximum 2 mm and make multiple passes until the required
depth is reached.
6)
Switch the machine off.
Note:
adding cutting oil will improve operation and increase the life span of the cutting plates.
