11
14.
Next splice the black wire of the transmitter box power cable to the reverse light’s
negative (-) wire or ground.
15.
Replace the reverse light bulb, and then re-install the light socket. Secure all the
wires with cable ties or electrical tape.
16.
Re-attach the negative battery cable to the battery.
TESTING THE SYSTEM
1.
Reattach the vehicle’s negative battery cable.
2.
Turn the ignition key to the accessory position, do not start the vehicle.
3.
Engage the parking brake, and then put the shifter in the reverse position.
4.
Turn the monitor ON by pressing the ON/OFF button on the monitor.
5.
Look at the monitor, if the image does not match your rear view mirror press the
Image Orientation button on the monitor to correct the image.
After testing the unit and you are satisfied with the route you have chosen for the
cabling, you must permanently install it.
Fully tighten the license plate bolts.
Route all wires behind interior panels or under carpeting so they are hidden.
Use supplied cable ties to neatly gather any excess wire.
TECHNICAL SPECIFICATIONS
Description
Test Condition
Nominal Value
Operating Voltage range
DC PowerSupply
12V
Operation Temperature
-10 to +45 °C
Storage Temperature
-20 to +80 °C
transmitter
Current consumption
with Transmitter Module
150mA
Image Sensor
1/4 inch Color CMOS
No. of pixel
640x480pixel
Camera View Angle
Measure Horizontal, 3m from camera
110 degree
Transmission frequency
using Spectrum analyser (select)
2.4 GHz
RF transmission distance
open
+/- 60m
Monitor
Display
2.4" TFT LCD
Video Input (wireless
receiver)
1x 2.4GHz
No. of pixel
480x240pixel