Introduction
|
9
EUT
P
OWER
O
UTLETS
Receptacles are usually mounted on the base of the turntable at the center axis
point. These receptacles can be custom mounted, flush with the tabletop on
some turntables. Contact ETS-Lindgren for information.
M
OUNTED
L
INE
I
MPEDANCE
S
TABILIZATION
N
ETWORK
A Line Impedance Stabilization Network (LISN) can be mounted to the underside
of some turntables. This option is only practical on larger turntables with sufficient
clearance.
A
DDITIONAL
F
IBER
O
PTIC
C
ABLES
Additional lengths of fiber optic cable may be ordered.
ETS-Lindgren Product Information Bulletin
See the ETS-Lindgren
Product Information Bulletin
included with your shipment
for the following:
Warranty information
Safety, regulatory, and other product marking information
Steps to receive your shipment
Steps to return a component for service
ETS Lindgren calibration service
ETS Lindgren contact information
10
|
Introduction
This page intentionally left blank.
Maintenance
|
11
2.0 Maintenance
Before performing any maintenance, follow the safety
information in the ETS-Lindgren
Product Information
Bulletin
included with your shipment.
Regularly inspect all equipment and conduct scheduled
maintenance in accordance with the factory recommendations
provided.
WARRANTY
BEFORE SERVICING: CONTACT ETS-LINDGREN
(+1.512.531.6400)—
Servicing or modifying the unit without
ETS-Lindgren authorization may void your warranty. If an
attempt to service the unit must be made, disconnect all
electrical power prior to beginning. Voltages exist at many points
within the instrument that could, if contacted, cause personal
injury. Only trained service personnel should perform
adjustments and/or service procedures upon this instrument.
Capacitors inside this instrument may still be charged even
when the instrument is disconnected from the power source.
Recommended Maintenance Schedule
Regular maintenance will prolong the effective operation and reliability of your
turntable. Follow the recommended schedule for 6-month and 12-month service.
Do not perform maintenance while the turntable is operating.
6-M
ONTH
S
ERVICE
Lubricate the casters with good quality bearing grease.
Check the gearbox for fluid leakage. A collection of slight film is normal, but
puddles of fluid are not normal. The gearbox is lubricated and sealed at the
factory. Under normal conditions, the gearbox should not require servicing
during its life.
12
|
Maintenance
12-M
ONTH
S
ERVICE
Lubricate the main bearing race with a grease gun containing good quality
bearing grease. The grease fittings are located inside the race, 90 degrees
apart, beneath the top. Three discharges from the grease gun in each fitting
are adequate.
Lubricate the gear teeth with good quality grease.
Replacement and Optional Parts
Following are the part numbers for ordering replacement or optional parts for the
Model 2187 Turntable.
Part Description
Part Number
Turntable assembly
For a list of all turntable parts, see the
drawings located in the back of this
manual.
IR Remote Controller
707030
NEMA connectors for slip ring
103441
Schuko connectors for slip ring
103351
Service Procedures
For the steps to return a system or system component to ETS-Lindgren for
service, see the
Product Information Bulletin
included with your shipment.