GB 8
OPERATION
Switching on
• Open the door to the dishwasher.
• Press the “on/off” button (9) to switch on the appliance.
The indicator (8) will light up when the machine is switched on.
• Select the desired cycle (see page 10 “cycle selection table”).
Press the programming button (2) repeatedly to select the required
cycle. The indicator (1) corresponding to the selected cycle will light
up.
• Close the door to the dishwasher. The dishwasher will automatically
start running the selected cycle.
Delayed start
If you want the dishwasher to switch on at a later time, you can used
the “delayed start” button (4). Each press on the button delays the start
by 1 hour. You can read the delayed start time on the display. You can
delay the start time by up to a maximum of 24 hours.
Selecting a half load
Press the “half load” button (8) to activate the half load cycle. The lower
spray arm is switched off during the half load cycle. This means that
you should only load the
upper
basket.
Stopping or changing a wash cycle
Open the door. Press and hold the programming button (2) for more
than 3 seconds. You can now re-select the desired cycle (see page 10
“cycle selection table”). Now close the door.
Note!
A cycle that has already begun can only be changed in the start-
up phase. After this, the detergent will be sprayed all over the dishes or
the machine may have already pumped out the water. In that instance,
you must refill the detergent compartment (see section on Dishwasher
detergent).
S trong
Auto
3 in1
Rinse
Norma l
Eco
Soak
Gla ss
Ra pid
P
1 2
Dela y
On/O ff
1
2
3
5
4
8
9
7
6
