ETNA KVV793 Series, Instructions For Use Manual

Page: 134 / 137

Cause or remedy: Problem:
Door is difficult to open:
• If you are trying to open the freezer door after just having closed it,
this could be difficult to do. As you open the door, some cool air
escapes from the appliance and it is replaced by warm air from the
environment. When this air is cooled, negative pressure is generated
which results in problems as you try to open the door. After a few
minutes, the condition is normalized and the door can be easily
opened again.
Appliance sides are
warm:
• This is normal. There are pipes and tubes installed in the appliance
sides, which tend to heat up during appliance operation.
LED lighting does not
work:
• If LED lighting does not work, call a service technician.
• Do not attempt a repair of the LED lighting yourself, as there is danger
of contact with high voltage!
Signal light above the 2,
3 or 5 indicator flashes
• Temperature sensor error or fault. Call a service centre for repair.
Until the appliance is repaired by a service technician, the appliance
will operate in safe mode. The appliance will automatically preserve
the most suitable temperature for each compartment.
Signal light above the D
or E indicator flashes:
• Sensor keys are not responding. Call a service centre for repair.
• Until the appliance is repaired by a service technician, the appliance
will operate in safe mode. The appliance will automatically preserve
the most suitable temperature for each compartment.
Signal light above the 8
indicator flashes:
• Door was open for too long. Close the door.
• If the lighting in the compartment does not function either, then there
is a door sensor fault. Call a service centre to arrange a repair. The
appliance will operate in safe mode until it is repaired. The appliance
will automatically preserve the most suitable temperature for each
compartment.
31