EN 17
General
If you notice a crack in the glass top (however small), switch the hob Off immediately, unplug
the hob, turn off the (automatic) fuse switch(es) in the meter cupboard or, in the event of a
permanent connection, set the switch in the power supply lead to zero.) Contact the service
department.
Troubleshooting table
If the appliance does not work properly, this does not always mean that it is defective.
Try to deal with the problem yourself first by checking the points mentioned below or
check for more information the website ‘
www.etna.nl/www.etna.be
’.
Symptom
Possible cause
Solution
The fan runs on for several
minutes after the hob has been
switched Off.
The hob is cooling down.
Normal operation.
A slight smell is noticeable the
first few times the hob is used.
The new appliance is
heating up.
This is normal and will
disappear once it has been
used a few times. Ventilate
the kitchen.
You can hear a ticking sound
in your hob.
Ticking can also occur at
lower settings.
Normal operation.
The pans make a noise while
cooking.
This is caused by the energy
flowing from the hob to the
saucepan.
At high settings this is
perfectly normal for some
pans. It will not damage
either the pans or the hob.
You have switched a cooking
zone On but the display keeps
flashing. A pan detection
symbol (U) will appear in
the display.
The pan you are using is not
suitable for induction cooking
or has a diameter that is
too small.
Use a correct pan.
When cooking, its seems as
if the zone continuously goes
on and off (the contents of the
pan boil, stop boiling, return to
the boil, etc).
This is the ‘switching’ of the
power: the cooking zone is
On, but the power switches
On and Off.
Normal operation; this is
a feature of this induction
hob (see ‘Switching of the
power’).
A cooking zone suddenly
stops working and you hear
a signal.
The preset time has ended.
Switch Off the signal by
pushing a random key.
TROUBLESHOOTING
Summary of Contents for KIV254KWIT
Page 83: ...DE 23...