EN 10
BEFORE FIRST USE
Minimum pan diameter
• The diameter of the bottom of the pan must be at least:
▷
90 mm for a cooking zone ø 145 mm
▷
110 mm for a cooking zone ø 210 mm
▷
110 mm for a cooking zone 210x180 mm
▷
210 mm for connected cooking zones 210 x 380 mm
• You will achieve the best results by using a pan with the same diameter as the zone.
If a pan is too small the cooking zone will not work.
Attention
Grains of sand may cause scratches which cannot be removed. Only put pans with
a clean bottom on the hob. We recommend that you lift pans and not slide them
over the hob.
Pan detection
• If the hob does not detect a (ferrous) pan after a power level has been set, the pan detection
symbol flashes in the display. After 5 seconds the cooking zone switches off.
• If you remove a pan from the cooking zone during cooking, the pan detection symbol
shows. The cooking zone switches off. The symbol disappears when you put the pan back.
The cooking zone switches on again with the power level that was set before.
Power level setting
The cooking zones have 10 power levels (0-9) and a ‘boost’ level (P). With the ‘Low range’
function you can set 9 more power levels in smaller steps. The levels in ‘Low range’ are used
for low or medium temperature cooking. Set the cooking level by touch and slide over the slide
control. At the first touch, the level is set according to the part of the slide control that you touch.
By slide over the slide control, the cooking setting is changed. By move to the right, the level
increasing, while moving to the left decreases the level. When you move your finger away from
the slide control, the cooking zone starts to operate at the level set.
Boost function
You can use the boost function to cook at the highest power level during a short period of time
(max. 10 minutes). After the maximum boost time the power will be reduced to setting 9.
Power limiter
The hob is equipped with a power limiter. If the total power of operating cooking zones exceeds
the maximum available amount of power, the power is automatically reduced. In the display of
