ETNA EKP327WIT, Manual

Page: 13 / 19

11
USE
Use
Switch on the hob
Before using your hob for the first time, each
element should be switched on to the highest
setting for 3-4 minutes, without a pan.
fig. 1
The manufacturer has applied a layer of rust-
preventer to each element. When the hob is
heated for the first time a burning smell will
be noticeable. This is normal.
Appliance information
The heating elements are made of cast iron.
he heat is created by spiral filaments which
lie in the element in rings.
The heat is transmitted to the base of the pan
by direct conduction. Each element is fitted in
a stainless steel sealing rim.
When one or more plates are in use the
control light on the panel will go on.
Pans
Use pans that are suitable for cooking by
electricity. Use pans with a thick and flat
base. If the base is concave or convex a lot
of energy is lost. The cooking process will
take very long. The element can become
overheated and warp.
Only place pans with a dry base on the
element. Moisture on the cooking elements
can cause rust.
fig. 2; good
fig. 3; wrong
Do not use pans that are smaller than the
cooking zone. This will prevent food spills
on the very hot cooking zone. Burnt-on food
spills are difficult to remove.