Installation manual (ver. 2/2018)
ETLOC-50 SECURITY
8
Note:
If the vehicle is equipped with a metallized windshield, it is necessary to place the GPS antenna, for
example, into the side mirror, front plastic bumper or other location where its view to the sky won't be
shielded. A heated windshield is not a problem for GPS signal reception.
4.
Activation of the unit
a) Attach the GPS antenna's SMB connector and wiring
harness connector to the vehicle unit (
after attaching
the cable harness, the vehicle unit is not yet
activated - it is still switched off
).
b)
Start the vehicle
and wait for approx. 2 minutes
(during this time the unit initializes). The LED lights on
the vehicle unit indicate its current state.
c) Send an SMS with the command
STATE
from your
mobile phone to the telephone number of the vehicle
unit. You will receive an SMS reply with information
about the installed unit
’s
current state.
1. IMEI
–
the unique identification
number of the vehicle unit
2.
Inputs states
IGNITION
/ ALARM
1 / ALARM 2
3. Switching relay state
4. STOP function state
Function STOP activation / Execution of STOP output
5. Vehicle battery voltage
6. Backup battery voltage
7. Charging of the backup battery
8. GSM signal power
9. GPRS state
Data transmission frequency / Data network connection
10. GPS module state
GPS module turned OFF/ON / Current position unknown/known
/ Number of visible satellites
d) T
urn off the vehicle’s ignition and resend the SMS with
the
STATE
command. In the reply
SMS, check that the IGNITION input is not active (INPUTS
0
/0/0).
After
turning the vehicle’s
ignition off, wait for approx. 5 minutes
and check if the vehicle
unit is still being powered (red LED must be flashing). With this procedure you will verify that
the circuit chosen for supplying power to the vehicle unit is not time-restricted and does not
cause the unit to switch off.
NOTE:
in order to
perform this test correctly, the backup
battery has to be disconnected during the test
.
IMPORTANT
STATE:
IMEI 866104028872547
INPUTS 1/0/0
SWITCH 0
STOP 1/0
CBAT 12,6V
BBAT 6,4V
CHARGE 0
GSM 28
GPRS I60s/1
GPS 1/1/5
Note: 0
–
no/off, 1
–
yes/on
state
LED is flashing 1 x
per second
The unit is connecting to
GSM netw ork
LED is flashing 1 x
per 3 seconds
The unit is connected to
GSM netw ork
LED is flashing 3 x
per second
The device is connected to
GSM and GPRS
LED is not flashing
The unit is sw itched off
LED is flashing 1 x
per second
The unit is trying to receive
GPS data
LED is flashing 1 x
per 3 seconds
The unit is receiving actual
GPS data
LED is not flashing
GPS module is sw itched off
Green LED – indicates GPS status
Red LED – indicates GSM status
