SFFR-6
User Manual
Getting Started
Doc ID: ES1002-UM02-v204a
Copyright © 2014 Etherstack London Limited
Page 13 of 39
2.2 Getting to know your GoBox
2.2.1 Locking Clamps
The GoBox has two locking clamps on either side of the Carry Handle to lock the lid firmly against the chassis.
To disengage the locking clamps, place your finger behind the clamps and pull away and up towards the lid. Lift the curved
section of the locking clamp up and out of the channel in the top of the lid and repeat for the other clamp to release the
GoBox lid.
2.2.2 Lid
The GoBox lid has been designed to prevent dust and water from entering the GoBox when the locking clamps are fully
engaged.
Both locking clamps must be fully engaged to ensure a correct seal.
!
Once the GoBox has been programed, the lid only needs to be opened to turn the GoBox on when powered under
batteries. The lid does not need to be closed during operation however it is recommended to be closed during
infield use.
!
The lid gasket located around the lid perimeter of the chassis must be kept clean and free of any debris. It should
be inspected before field operation and cleaned or replaced if damaged otherwise water or dust could penetrate
and damage GoBox electronics.
!
