22
FCC Statement to the User
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by
the party responsible for compliance could void the user’s
authority to operate this equipment.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the
following measures:
• Reorient or relocate the receiving antenna.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Increase the separation between the equipment and
receiver.
• Consult the dealer or an experienced radio/TV
technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits
set forth for an uncontrolled environment. End users must
follow the specific operating instructions for satisfying RF
exposure compliance. To maintain compliance with FCC RF
exposure compliance requirements, please follow operation
instructions as documented in this manual. This transmitter
must not be co-located or operating in conjunction with
any other antenna or transmitter. This equipment should
be installed and operated with a minimum distance of 20
cm between the radiator and your body. The availability of
some specific channels and/or operational frequency bands
are country dependent and are firmware programmed
at the factory to match the intended destination. The
firmware setting is not accessible by the end user.
Summary of Contents for EM-SF3
Page 25: ...25 Connect with us Etekcity ...
