408-10243
Rev
E
2
of 5
7. Place the nut onto the end of the long screw and tighten the nut enough to hold the locator assembly
in place, while still allowing the locator to slide up and down.
8. To disassemble, close the tool handles until the ratchet releases, remove the nut, the locator
assembly, the two die retaining screws, and slide the anvil and crimper out of the tool jaws.
NOTE
The ratchet has detents with audible “clicks” as the handles are closed. The ratchet releases on the sixth “click”.
Figure 2
4.
CRIMPING PROCEDURES
NOTE
Prior to stripping the cable, make sure to slide the strain relief and shell onto the cable and away from the stripping area. See
Figure 2.
NOTE
This tool is provided with a crimp adjustment feature. Initially, the crimp height should be verified as specified in Figure 7.
Refer to Section 5, Crimp Height Inspection, and Section 6, crimp height Adjustment, to verify crimp height before using the
tool to crimp desired contacts and wire sizes.
1. Strip the cable jacket to 9.50 ±0.25 mm [.374 ±.010 in.] as shown in Figure 2.
2. Insert the discrete wires into the wire holders according to the wiring diagram provided in Figure 3 until
bottomed. After wire insertion, the holders shall be sandwiched on the plug body prior to crimping. See
Figure 3.
Figure 3
Stripped Cable Jacket
9.50 ±0.25
[.374 ±.010]
