-9-
①
High voltage detector
②
Main engine
③
Low-voltage current clamp
1 High-voltage current clamp
2 LED power indication of HV detector
3 Power key
4 Joints of insulation rods
5 Input interface for low-voltage current
6 LCD monitor of the main engine
7 HOLD key
8 RS232 Interface
9 Output plug for low-voltage current clamp
10 Low-voltage current clamp
11 Insulation Rods
VI Operation
Before using the tester, examine whether there
is any part broken; if no, it can be put into use.
Install the battery according to the manual.
1. Switch of high voltage detector
Press
POWER
to start the detector, and the
POWER
indicating light is on. The detector will begin to do automatic
detection and send the result to the main engine by wireless
transmission. If the indicating light keeps flickering about 15
minutes after the detector is started, this will present an
automatic shutdown and after it keeps flickering for about 30
seconds, the detector will be shut down automatically to
reduce battery consumption. During the flickering of the
POWER
indicting light, pressing
POWER
will make the detector
continue to work. Press
POWER
will shut down it.
