-
11
-
General Test: In the process of test, it will show the tested
current value on real time by LCD display, and LCD data will
vary with the current change. When the tester is removed
away from the lead on test, it will not preserve the test result,
LCD display will return to zero.
In general test mode, it is suitable for close distance
measurement, convenient for circuit test by direct read of LCD
data.
(*
Special note: ETCR9000A type adopts infrared
transmission of test data, which has no limit for read
display data on receiver. The display date on receiver are
totally the same with display emission data of tester, so it
is very straight no matter in which test way by using
ETCR9000A type.
)
Before test, firstly to connect insulation rod, which
must be connected in right position, and then to
connect tester, avoiding the impact of meter to
ground surface.
Make sure to use specially equipped insulation
rod to connect with the meter.
After test, it should incline the insulation rod
accordingly on drawing in. Firstly to tear down the
tester and then the insulation rod, avoiding the
impact of meter to ground surface.
After normal boot, place the lead in the middle of clamp
transducer domain, as shown in Figure A, with the meter
transducer domain perpendicular to the lead, pushing the
meter forwards to clamp the lead on test, showing the result
on LCD display. If showing "OL A", it means the lead current
on test has exceeded the maximum volume on the level.
Please select a higher gear level or a meter with greater
measurement limit.
To pull backwards can make the meter remove from the
lead on teat, as shown in Figure C, on removing, please try to
keep the meter transducer domain perpendicular to the lead.
Summary of Contents for 9000
Page 1: ...Catalogue ...