10
Echo Relay Panel Feedthrough Installation Manual
Relay Ratings
• Inrush: 2000A
• Isolation: 5000V RMS
• Life: 60,000 cycles at full load
• Relay output terminals accept 1.5 - 4mm
2
(14-10 AWG) copper wire
Verify the Contents of the Shipping Carton
Standard ERP-FT units ship complete and fully pre-wired with low-voltage relay control. As
you remove the Relay Panel from the shipping carton, confirm the following items are
included:
• ERP-FT with cover(s) and locking door(s) attached with key(s).
• Relay panel interior(s) with the quantity and type of relay ordered
• DMX Preparation Kit - ETC part number 4100A1002
• Echo Relay Panel Feedthrough Installation Manual
Parts and Specialty Tools Required
The following parts and specialty tools are required, but not supplied, for installation:
• 6-8mm (1/4” - 3/8”) bolts or screws, 50-100mm (2-4”) long, and suitable wall plugs, are
suggested for Relay Panel mounting.
• Conduit punch, Conduit or bushes - 12.7mm (1/2”) diameter
• Phillips screwdriver
• Slotted screwdriver
• Jeweler’s slotted screwdriver
• Wire strippers
WR6172-84 Double Pole 480V HID Relay
CSA
UL Listed
• General Use
20A @ 347VAC
• General Use
20A @ 480VAC
• Ballast (Standard)
20A @ 347V AC
• Ballast (Standard)
20A @ 480VAC
• Tungsten
2400W @ 120V AC
• Tungsten
2400W @ 120V AC
• Motor Load
1/2 HP @ 110-125V AC
• Motor Load
1/2 HP @ 110-125V AC
1-1/2 HP @ 220-250V AC
1-1/2 HP @ 220-277V AC
•Short Circuit Rating 5,000A 277VAC
• Short Circuit Rating
5,000A 277VAC
Note:
Accessory options are packaged separately.
