ETC ColorSource Manual Download Page 2

Page: 2 / 3

2. Using the #1 Philips screwdriver, remove the screws of the flat bottom panel shown below. Remove the flat

bottom panel and set aside

a. 20-fader consoles will have (7) screws

b. 40-fader consoles will have (8) screws

c. Note that the screws in the middle of the console will have longer screws. Separate these

screws from the shorter screws

I. 20-fader consoles will have (3) long screws

II. 40-fader consoles will have (4) long screws

3. Remove the screws from the back panel (the side with the DMX port(s)). Remove the curved bottom panel

and set aside

a. 20-fader consoles will have (8) screws

b. 40-fader consoles will have (10) screws

4. Perform any needed repairs/troubleshooting

Updated: Fri, 17 Sep 2021 16:16:14 GMT

Summary of Contents for ColorSource

Page 1: ...ffiliates are not responsible for any damage or injury caused by service of our products by anyone other than us or our authorized service providers and such damage is excluded from the product s warr...

Page 2: ...rom the shorter screws I 20 fader consoles will have 3 long screws II 40 fader consoles will have 4 long screws 3 Remove the screws from the back panel the side with the DMX port s Remove the curved b...

Page 3: ...r screws should be reinstalled in the middle 3 or 4 screw holes Installing these screws in any other place can damage the fader board or the control board Parts ETC Part Numbers Short Screws HWM1169 L...