ENGLISH
19
K selections starts from 1.000 and pressing ◄► value can reach up to 20.000 or down to 0,000.
K1 select 1.000
K5 select 5.000
Controller will adapt Measurement and Display resolution according to the type of probe used as shown in page 13;
IMPORTANT: once selected EC probe K factor, ENSURE, to connect the proper Conductivity sensor.
In case, the user wished to change the EC K RANGE, even during operations:
from
∗
BASIC
∗
menu, move to > SETTINGS > CALIBRATION > EC probe K factor
from
∗
EXPERT
∗
menu, move to > MAIN MENU > CALIBRATION > EC probe K factor
Press ESC to return to MAIN MENU or Press ESC ESC to CONTINUOS MEASUREMENT display.
TEMPERATURE settings
Manual temperature compensation 0÷100°C.
Press ◄► to show the environmental temperature.
Selecting AUTO compensation temperature/electrode
measurements, always giving the exact value against the current
temperature.
Press ◄► to show the environmental temperature to calibrate
sensor.
Programming MENU
eSelect-CD1 series allows choosing between:
•
BASIC programming: simplified mode for not professional operators
•
EXPERT programming: complete programming including functions for a more refined control and results
Once selected the programming menu, Menu and submenus will change accordingly.
To help operator to choose the correct menu here following the main difference between the two menus:
Setpoint 1-2 Setpoint Value - Dosing Mode - Mode ON/OFF or Timed Pulses - Alarm
MIN/MAX - Priming > Calibration > Settings
Setpoint 1-2 Setpoint Value - Dosing Mode - Mode ON/OFF or Timed Pulses -
Hysteresys - Delay - Temperature correction Alarm MIN/MAX - Overdosing - Startup
Delay - Priming > 4-20mA > Calibration > Settings
Press OK/MENU display shows BASIC mode (default):
◄
►◄
►
Selecting either one of the two menus, will change
the Main Menu programming accordingly.
In case the user wished to change the operating Menu, after the initial selection and even during operations, move to > SETTINGS
menu than go to > PROGRAMMING steps.
◄
►
Press ESC to return to MAIN MENU or press ESC ESC for CONTINUOS MEASUREMENT display.
After selecting, e.g. choosing EXPERT, at first display will still show Basic but as soon as moving to other steps it will change
to Expert, and vice versa.
CONTROLLER SETTINGS
Temperature
XX°C
CONTROLLER SETTINGS
Temp. Probe
Manual
CONTROLLER SETTINGS
Temp.Probe
Auto
EC METER SETTINGS
EC probe K factor
1.000
CONTROLLER SETTINGS
Programming
BASIC
CONTROLLER SETTINGS
Programming
EXPERT
Select Menu
Settings
Menu
EXPERT
Menu
BASIC
Select Menu
EXPERT
Select Menu
BASIC
