XETK-V1.0 - User’s Guide
39
ETAS
Technical Data
7
Technical Data
The “Technical Data” chapter contains a summary of all technical data, pin
assignments and hints to system requirements for operating the XETK-V1.0.
7.1
System Requirements
7.1.1
ETAS Hardware
Compact Hardware: ES510, ES600 (INCA)
ES910 (INCA, INTECRIO)
7.1.2
Ethernet Interface of the PC
A PC with a free Ethernet interface (1 GBit/s or 100 Mbit/s, Full Duplex) with an
RJ-45 connection is required. Ethernet interfaces realized by an additional PCM-
CIA network card in the PC must have a 32-bit data bus (card bus).
The manufacturers of the network cards have different names for this function.
Example: “Link down Power saving
7.1.3
Software Support
You need following software versions to support the XETK-V1.0:
7.2
Supported Microcontroller
Note
The XETK-V1.0 can be shipped in the two different mechanical versions XETK-
V1.0A and XETK-V1.0B (refer to chapter 7.11.1 on page 49 and chapter
7.11.2 on page 50).
Note
It is imperative you disable the function which automatically switches to power-
saving mode on your PC network card when there is no data traffic on the
Ethernet interface!
Software
Version (or higher)
HSP (Firmware)
6.0.1
INCA
6.0.0 HF1
Item
Characteristics
Supported microcontrollers
VertiCal base board with Freescale
MPC5534, MPC5553, MPC5554,
MPC5565, MPC5566, MPC5567,
MPC5674F