ETAS ES5350.1, User Manual

Page: 17 / 40

ES5350.1 - User’s Guide 17
ETAS Design, Installation and Fuses
2 Design, Installation and Fuses
This chapter contains information about the design and installation of ES5350.1
plug-in card, as well as information about the fuses.
• "Voltage Supply of ES5350.1 Plug-in Card" on page 17
• "Fuses" on page 18
– "Position of Fuses" on page 19
– "Specification of Fuses" on page 19
– "Ordering Data of Fuses" on page 19
• "Installation in the ES5300.1-A and the ES5300.1-B Housing" on page 20
2.1 Scope of Supply
You can find the scope of supply in chapter "Ordering Data" on page 36.
2.2 Voltage Supply of ES5350.1 Plug-in Card
The ES5350.1 plug-in card is supplied via the backplane of the ES5300.1-A or
ES5300.1-B housing. The electrical connection is done via backplane connector
CO200.
Fig. 2-1 Backplane connector CO200 to voltage supply
CAUTION!
Some components of the ES5350.1 plug-in card can be damaged or
destroyed by electrostatic discharges. Leave the plug-in card in its
transport packaging until it is installed.
Only remove, configure and install the product at a workplace that is
protected against electrostatic discharges.
Note
Additional information about power consumption is located in the technical
data in the chapter "Voltage Supply (Backplane Connector)" on page 34. Infor-
mation about the pin assignment of the backplane connector CO200 is located
in the chapter "Pin Assignment - Backplane Connector CO200" on page 28.
CO200