BM04101 Molift Quick Raiser English - Rev F 09/2012
Page 7 of 20
Assembly and disassembly
Unpacking
• The lifter comes in a cardboard box. Verify that
the box has no apparent damage. If damaged, -
check the contents and contact your dealer for
assistance if components are damaged.
• The box contains as standard a chassis, lifting
column, knee support, lifting arm, drive handle,
hand control, battery, battery charger, power
chord and documentation.
Parts from lifters with different lifting
capacity must not be used.
Assembly
The battery must not be in the battery holder
on the column during assembly!
• At the bottom of the column there are two
bolts for fixing the column to the chassis. Loos-
en the bolts enough to slide the column into
the chassis until the red arrow on the front is
pointing on the edge of the chassis (see pic-
ture). Tighten the bolts properly with the Allen
key on the top of the column (see page 10) to
fix the column to the chassis. Both bolts must
be attached to chassis.
The QR2+ column has a pin in the bottom to
be fitted in the chassis.
• If the column stops before the arrow has
reached the edge, you will have to retract the
column and try turning the motor spline head
to align it with the connector at the base of the
column.
• Assemble the knee pad bracket on the col-
umn by removing the locking wheel. Place
the knee pad bracket around the column and
on the bolt where the locking wheel is placed
and tighten the locking wheel. Make sure the
bracket is placed with the level side up.
• Slide the driving handle onto the top of the
column by guiding the head of the fixing knob
into the T-groove of the column. The handle
shall be pointing upwards, as shown on the
picture below. Tighten the knob firmly when
the handle is in the desired position.
• Guide the wire of the hand control through the
ring at the base of the drive handle. The hand
control has a hook enabling it to hang on the
handle.
Locking wheel
for knee support
Fixing bolts
for column
Arrow