eta Twin Screw Agitator, Operating Instructions Manual

Page: 17 / 28

Installation
17
Slide the drive onto the drive shaft and fasten it.
Tighten the screws alternately and evenly.
Fig. 4-34: Screws
Installing the discharge drive
Align the screw conveyor with the drive using the
feather key.
Fig. 4-35: Drive
Slide the drive onto the screw conveyor and fasten it.
Tighten the screws alternately and evenly.
Fig. 4-36: Screws
Installing the bleed screw
The gearbox is already filled with oil from factory and
closed with a plug screw. Remove this plug screw and
keep it with the gearbox in event of a return, so that oil
does not run out.
Fig. 4-37: Plug screw
Install the bleed screw in place of the plug screw.
Fig. 4-38: Bleed screw
Tightening the screws
Tighten all the screws alternately and evenly.