eta Twin Screw Agitator, Operating Instructions Manual

Page: 15 / 28

Installation
15
Fig. 4-27: Screws
Checking the wall distance
Turn the floor agitator by hand and check the
clearance from the storeroom walls. Then align the
floor agitator in the centre of the storeroom, so that the
wall clearance is uniform.
Finally, turn the floor agitator one full turn and check
the clearances again.
If the spring arms scrape the walls, the walls must
be protected with boards.
Checking the floor distance
Turn the discharge by hand until the end of the leaf
spring reaches the lowest point in the storeroom. The
clearance between the spring arm and the floor must
be a minimum of 10 mm.
Fig. 4-28: Floor distance
If you install a slanted floor, also take the
thickness of the boards into account.
Check if the clearance is the same for all other spring
arms and adjust them if necessary.
Adjust the height of the support stand so that the
trough is not sagging or overhanging.
Fig. 4-29: Adjusting the support stand
Fill the wall opening with mineral wool and plaster
the wall.