eta FRIO 1607, Instructions For Use Manual

Page: 16 / 40

– The appliance cannot be used in bathrooms in zones 0, 1 and 2 HD 384.3 S1! It must
not be used in close proximity of bathtubs, a shower or a swimming pool.
– The appliance must not be used in damp or wet environment and in any environment with
the danger of fire or explosion (spaces where chemicals, fuels, oils, gases, paints and
other flammable or volatile materials are stored).
– Use the appliance in the working position only at places with no risk of turning over and in
a sufficient distance from objects (such as curtains, drapes, etc. ), heat sources
(e.g. fireplace, heater, stove, cooker, radiators, hot air ovens, grills ) and wet surfaces
(e. g. sinks, wash basins ).
– Make sure that impurities do not enter into the appliance (e.g. clouds of dust, hair etc. ).
– Do not put the switched on fan on soft surfaces (e.g. on a bed, towels, wipers, carpets ).
– There must not be any device with open flame in the flow of the air coming out from the
appliance because of danger of burning process interruption.
– Never let the flow of air blow on you (or animals) for an extended period of time. It may
cause health problems.
– Never put the power cord on hot surfaces or do not let it hang over the edge of a table or
a work top. Plugging or pulling the power cord e.g. by children can result in tilting over or
drawing the appliance down and serious injury!
– The power cord must not be damaged with sharp or hot objects, open fire, it must not be
sunk into water or bent over sharp edges.
– Do not wind the power cord around the appliance, this will extend life of the power cord.
– Use this appliance only for the purpose for which it was designed as specified in this user‘s
manual. Never use the appliance for any other purpose.
– The producer does not guarantee any loss caused by improper handling of the appliance
and its accessories (e. g. electrical accident, fire ) and its guarantee for the appliance
does not apply in the case of non–compliance with the safety instructions above.
II. DESCRIPTION OF THE APPLIANCE
A – Drive unit
A1 – Holder for handling
A2 – Shaft
A3 – Adjustable joint angle
A4 – Power cord
A5 – Extension pole (2x)
A6 – Base
A7 – Rear grill
A8 – Grill nut
A9 – Blade
A10 – Blade nut
A11 – Plastic connecting collar
A12 – Screw
A13 – Front grill
B – Control panel with LED indicating lights
B1 – Oscillation adjustment button
B2 – Timer setting button
B3 – Mode button (NORMAL/NATURAL/SLEEP)
B4 – Speed setting button
B5 – ON / OFF button
16
GB
/ 35