Installation
13
Fasten the ball joint connection on the drop chute with
the threaded rods. Only hand-tighten the nuts initially.
Adjusting the support stands
As soon as the end position and alignment of the inter-
mediate conveyor screw has been determined, adjust
the support stands. They must rest completely on the
ground for later attachment.
Fig. 4-18: Support stands
Installing the discharge drive
Align the screw conveyor with the drive using the
feather key.
Fig. 4-19: Drive
Slide the drive onto the screw conveyor and fasten it.
Tighten the screws alternately and evenly.
Fig. 4-20: Screws
Installing the bleed screw
The gearbox is already filled with oil from factory and
closed with a plug screw. Remove this plug screw and
keep it with the gearbox in event of a return, so that oil
does not run out.
Fig. 4-21: Plug screw
