16
GB
Hours setting
Set the correct time by pressing or holding down the
HOUR
button.
Minutes setting
Set the correct time by pressing or holding down the
MIN
button.
Setting the timer
Press the
PROG
button and the indicator
AUTO
will start to flash. Set your desired time of
coffee preparation by pressing the
HOUR
and MIN buttons. Then press the
ON/OFF
button
(the red indicator
AUTO
will light up). The timer function is programmed.
Turning on the coffee maker
Press the ON/OFF button twice and the device starts operating (the ON indicator is on).
Turning off the coffee maker
Press the ON/OFF button and the coffee maker will turn off (the ON indicator will switch
off).
IV. INSTRUCTIONS FOR USE
Remove all packaging material. Remove all adhesive foils, stickers or paper from the
appliance. Place the device on a flat surface and connect the plug of the supply cord
A6
into the electric outlet. Set the actual time (for
ETA 7174
) Rinse the water system before
first use. Fill the tank with water to measure 12, turn the device on (without the filters and
coffee). Pour the water out of the kettle and repeat approx. twice after the cycle is finished.
Fil
ter
The device is equipped with a permanent filter
B1
, in which ground coffee is put. If
you wish to use paper filters, we recommend paper filters s
ize no. 4
or
1x4
which are
commonly available in all domestic appliances shops.
Do not forget to bend the edges of
the paper filter before putting it into holder B to avoid tearing and creasing
. Dispose
of the used paper filter with the coffee with other common waste.
Coffee preparation
Tip out the
A1
lid. Fill the
A2
tank with fresh cold drinking water in such amount that
corresponds with your consumption. On the scale of the
A3
watermark, the symbol (-) is
for big cups (120 ml), symbol (
•
) is for small cups (80 ml). Tip out the holder by pulling it
slightly
B
. Using the measure
D
, pour the desired amount of ground coffee into filter
B1
and close the holder with a snap.
- for big cups:
use one flat measure of ground coffee (approx. 5 g) per one cup
- for small cups:
use 3/4 measure of ground coffee (approx. 3.3 g) per one cup.
Put the kettle
C
on the heating plate
A4
and make sure that the container lid is closed.
The coffee maker is set to operation by switching the
A5
switch into position
I
(with
ETA
7176
), with (
ETA 7174
) by double-pressing the
ON/OFF
button on the control panel
A5
.
The preparation and heating mode is indicated by the indicator light. After the preparation
is finished, the coffee maker switches automatically into the heating mode and will keep the
coffee hot. If you wish to turn the coffee maker off, switch it to position
0
(with
ETA 7176
)
and press the
ON/OFF
button (with
ETA 7174
) and the indicator light will switch off.
