7.3 Pump Filter
The pump filter system in your Washing
Machine prolongs the life of the pump by
preventing lint from entering your machine.
We recommend that you clean the pump
filter every 2 months.
The pump filter is located behind the cover
on the front-lower right corner.
To clean the pump filter:
1. You may use the washing powder
spade (*) - if supplied with your
machine or liquid detergent level plate
to open the pump cover.
2. Lodge the end of the powder spade
or liquid detergent level plate in the
opening of the cover and gently press
backwards. The cover will open.
• Before opening the filter cover, place
a container under the filter cover to
collect any water left in the machine.
• Loosen the filter by turning
anticlockwise and remove by pulling.
Wait for the water to drain.
NOTE:
Depending on the amount of
water inside the machine, you may
have to empty the water collection
container a few times.
3. Remove any foreign materials from the
filter with a soft brush.
4. After cleaning, re-fit the filter by
inserting it and turning clockwise.
5. When closing the pump cover, ensure
that the mountings inside the cover
meet the holes on the front panel side.
6. Close the filter cover.
WARNING:
The water in the pump
may be hot, wait until it has cooled
down before carrying out any
cleaning or maintenance.
(*) Specifications may vary depending on
the machine purchased.
7.4 Detergent Drawer
The use of detergent may cause residual
build up in the detergent drawer over time.
We recommend that you remove the drawer
every 2 months to clean the accumulated
residue.
To remove the detergent drawer:
•
Pull the drawer forwards until it is fully
extended.
•
Press the region shown below inside
the detergent drawer you have pulled
all the way back, and continue pulling
and remove the detergent drawer from
its place
38
GB
/ 42
