•
Your Washing Machine requires
a 220-240V, 50 mains supply.
•
The mains cord of your washing machine
is equipped with an earthed plug. This
plug should always be inserted to an
earthed socket of 10 amps.
•
If you do not have a suitable socket
and fuse conforming with this, please
ensure the work is carried out by
a qualified electrician.
•
We do not take responsibility for
damage that occurs due to the use of
ungrounded equipment.
NOTE:
Operating your machine with
low voltage will cause the life cycle
of your machine to be reduced and
its performance to be restricted.
3.4 Water Inlet Hose Connection
1. Your machine may have either
a single water inlet connection (cold)
or double water inlet connection (hot
and cold) depending on the machine
specifications. The white capped hose
should be connected to cold water inlet
and red capped hose to the hot water
inlet (if applicable).
• To prevent water leaks at the joints,
either 1 or 2 nuts (depending on
your machine’s specifications) are
supplied in the packaging with the
hose. Fit these nuts to the end(s) of
the water inlet hose that connect to
the water supply.
2. Connect new water inlet hoses
to a ¾ ˝, threaded tap.
• Connect the white capped end of the
water inlet hose to the white water
inlet valve on the rear side of the
machine and the red capped end of
the hose to the red water inlet valve
(if applicable).
• Hand tighten the connections. If in any
doubt, consult a qualified plumber.
• Water flow with pressure of 0.
1-1 Mpa will allow your machine
to operate at optimum efficiency
(pressure of 0. 1 Mpa means that
more than 8 litres of water per minute
will flow through a fully opened tap).
3. Once you have made all of the
connections, carefully turn the water
supply on and check for leaks.
4. Ensure that the new water inlet hoses
are not trapped, kinked, twisted, folded
or crushed.
• If your machine has a hot water inlet
connection, the temperature of the
hot water supply should not be higher
than 70°C.
NOTE:
Your Washing Machine must
only be connected to your water
supply using the supplied new fill
hose. Old hoses must not be reused.
3.5 Water Discharge Connection
•
Connect the water drain hose to
a standpipe or to the outlet elbow of
a household sink, using additional
equipment.
GB
17 / 42
