eta 002895040, Instructions For Use Manual

Page: 18 / 36

P2 – Lock button P5 – Cleaning attachment
P3 – Grater for cubes
III. PREPARATION AND USE
Remove all packaging materials, take out the all accessories. Remove all adhesive foils,
stickers or paper from the accessories. Before first use clean the parts that will come in
contact with food using warm water with detergent, thoroughly rinse with clean water and
wipe dry, if necessary allow to dry.
DISC CUTTING ATTACHMENT - CUBES (P)
Assembly (pic. 2, 3, 4, 5, 6, 7, 8, 9, 10)
Insert the grater P3 (hold it by the top plastic part) so that the protruding part on its edge
fits exactly to the moulded hole on the edge of the holder P1 . Four lock button P2 by slight
pushing and turn (unlock). Insert the grater P4 hold it by the top plastic part, (blades facing
up) insert the holder P1 . Insert the grater P4 hold it by the top plastic part, (blades facing
up) into holder P1 and secure it by slight pushing. Four lock button P2 by slight pushing
and turn (lock up), (you will hear snapping sound). The grater must be in line with the
holder. Insert the drive shaft M1 into the opening of the bowl M . Hold the holder P1 (with
installed grater) at the upper plastic part and through the central opening is inserted at the
drive shaft
M1
put it in the respective container
M
so that the lugs on its edge snap into the
moulded holes in the container. Put the lid M2 on bowl M so that the moulded hole on its
edge fits exactly to the protruding part on the edge of the bowl. Turn the lid clockwise. Pay
special attention to this operation. ATTENTION: The lid is mounted correctly when the
arrow points exactly to the symbol on the handle . The lid is now secured in the correct
position. Insert the cover M4 on the outlet of the bowl M until it stops. Take the assembled
bowl and insert it on the gearbox N through the central opening and turn it clockwise until
it stops. Pay special attention to this operation. When disassembling the grater, proceed in
the opposite way.
Installation on to the multi-function head (pic. 11)
Insert the assembled slicer into the mount at an angle of approximately 45
o
and secure in
a horizontal position by turning anticlockwise (you will hear a click). Now the slicer is ready
for operation. To disassemble the entire slicer the release button, turn the slicer clockwise
and pull it out of the multi-function head mount (pic. 15)
Food preparation
Use the food processing attachment to chop - cubue. You can slice carrot potato celery,
horseradish, beets, parsley, cucumber, courgette, radish, onions, peppers, apple, pear,
melon, pineapple, mango, sausages and foods of a similar texture.
Attention
– The plates are sharp, handle with care when fitting, removing and cleaning.
– For best results when using the slicing plates, the sweeper arm should be positioned
opposite the blade (pic. 7).
– It is recommended to cut tough ingredients into small pieces. Do not process very hard
materials (e.g. parmesan cheese etc.).
– After using a cutting plate there will always be a small amount of waste on the plate or in
the food. This not a defect and the slicer cannot be subject to a complaint for this reason.
!
18
GB
/ 32