GB
OPERATING INSTRUCTIONS
PD-C180i KNX ECO
EP10426452
PD-C180i KNX ECO DK
EP10426476
PD-C180i KNX ECO CH
EP10426490
www.esylux.com
5 /6
BESCHREIBUNG DER APPLIkATION
• Additional manual lighting control in “Fully automatic” mode
The lighting can be switched on or off manually using infrared remote
control (Mobil-PDi/User, refer also to the separate Mobil-PDi/User
instructions) or by telegrams, e.g. by pressing external KNX/EIB buttons.
If manual operation when persons are present is set, despite high ambient
brightness conditions (ambient lighting level is higher than the pre-set light
value), the artificial light will remain switched on for as long as the detector
continues to detect movement. If no more movement is detected, the lighting
is switched off after the set switch-off delay time has elapsed. The lighting
can be subsequently switched back on manually at any time. If the artificial
light is switched off manually, the lighting will remain switched off for as
long as the detector continues to detect movement.
If manual operation during off-period is set, during this time the detector
behaves in the same way as when set for manual operation when persons
are present. The detector then switches to normal operating mode. In this
way, the light can be switched on by the user despite the threshold value
being exceeded, and then switched off automatically after the set time has
elapsed.
If no more movement is detected, the detector will revert to the previous
automatic mode after the set switch-off delay time has elapsed.
NB: Applies to all light channel operating modes.
• “Semi-automatic” operating mode
If “semi-automatic” mode has been selected, the lighting must be switched
on manually using infrared remote control (Mobil-PDi/User) or by
telegrams, e.g. by pressing external KNX/EIB buttons. This means that the
detector does not automatically switch “ON” the lighting when persons are
present.
However, should the natural lighting level increase and the ambient lighting
level exceed the pre-set light value, the detector will automatically switch
the lighting off 5 minutes after reaching the pre-set light value, regardless of
any presence.
The lighting can subsequently be switched back on manually at any time.
If manual operation during off-period is set, during this time the detector
behaves in the same way as when set for manual operation when persons
are present. The detector then switches to normal operating mode. In this
way, the light can be switched on by the user despite the threshold value
being exceeded, and then switched off automatically after the set time has
elapsed.
NB: External ON telegram, e.g. via kNX/EIB button, is essential in “semi-
automatic” mode. Applies to all light channel operating modes.
Default setting: Fully automatic
8.3 Switch-off delay time light channel
• Switch-off delay time channel light
Options: 0 seconds, 30 seconds - 30 minutes
Default setting: 5 minutes
8.5 Processing actuator acknowledgement
An actuator’s status object can be processed via objects 9 and 10. If the
actuator is not only controlled by the detector, the light channel switches to
standby mode if the status of the channel and actuator differ.
8.6 Sending in cycles
The light channel sends its current status in cycles according to set time
intervals. At the same time a setting can be made to define whether it
should repeatedly send ON or OFF telegrams in cycles.
