Eswood UT-20 Series, Equipment Manual

Page: 7 / 20

UT-20 UTENSIL WASHER MODELS UT20H & UT20P – JUNE 2011 7
I
NSTALLATION
UT-20 UTENSIL WASHER
(INCLUDES UT20H & UT20P MODELS)
4
Installation Instructions
1. Remove the packing materials from the machine, including
inside the chamber.
2.
Remove the lower front panel, position the machine and level
by screwing the adjustable feet. Leave 500mm free on the left
side under bench level for servicing.
3.
Connect the 2” B.S.P. gravity drain via a 2” trap to the drain
outlet. Connect the hot water supply via a min ½ ”isolating
valve (adjacent to the unit) to the ½ B.S.P. union at base of
machine. The water supply to be a minimum temperature of
65
°
C and a pressure of 200-400 kpa.
Note: All plumbing work is to be done in accordance with local
plumbing codes.
4.
Ensure that the rotary switch is in the “OFF” position then open
the control panel and connect the 3-phase power + N via an
isolating switch (near machine) to the terminal block market L1,
L2, L3 & N, connect the Earth to the “E” terminal. Check
rotation of the wash motor is as per the arrow on motor
housing (anti clock at motor end). Maintain rotary switch in
“OFF” position.
Note: all electrical work is to be done by qualified trades
person in accordance with local codes and as per the rating
plate.