Eswood UT-20 Series, Equipment Manual

Page: 10 / 20

UT-20 UTENSIL WASHER MODELS UT20H & UT20P – JUNE 2011 10
S
HUTDOWN AND MAINTENANCE
UT-20 UTENSIL
WASHER (INCLUDES UT20H & UT20P MODELS)
7
1. Turn the rotary switch to the "OFF" position.
2.
Open door, remove Strainer Basket and Strainer Screens.
Empty contents into bin, then wash under tap. Remove the
Overflow Tube allowing the was tank to drain and
do not refit
at this point.
3.
To flush out the inside of machine, with door closed turn the
switch to “FILL”, press “START” button and complete the cycle.
Turn rotary switch to “OFF” position.
4.
Check that the Wash and Rinse arm jets are free of foreign
matter. If necessary remove the arms and clean under tap.
Check that the Arms spin freely.
5.
At this point place Overflow and Strainer Screens and basket
back into wash tank. Close the door. Clean the exterior with a
damp cloth.
Do not pass damp cloth over the electrical
controls. Avoid abrasives or strong detergents in the cleaning
process.
6.
Leave door partially open, if possible, allowing the machine to
be air dry.
7.
Eswood recommends investing in a M.I.S. (Machine Inspection
Service) contract, to help protect your investment by increasing
the life and efficiency of your machine. This service is
available in capital cities and regional centres where
recommended Eswood service agents are located. Contact
Eswood for further information.