Content
2.2 Location
The device is intended for the installation only in enclosed spaces. After choosing the
place of installation, make sure it meets the following conditions:
1. The installation place must be free of excessive moisture and flammable vapours or
vapours causing corrosion.
2. The installation of device cannot be made near electrical equipment of high power,
electrical machines or welding equipment.
3. In the place of installation the temperature of ambient cannot exceed 60ºC and it
should not be lower than 0ºC. Humidity should range from 5% to 95% without
condensation.
2.3 Installation
The module should be mounted on the wall in the room selected. There should be a free
air circulation in the place of installation and the place should be away from the heating
sources, for example, electronic equipment, fireplace, heater or direct solation. It is
recommended that the module be mounted at a height not less than 1,5 m over the floor.
estyma electronics
www.estyma.pl
page 7
PL20130524
Summary of Contents for Vide
Page 1: ......
Page 2: ...page 2 PL20130524...
