28
V.1.0
installation
•
Before plugging the appliance into the mains socket for the first time, allow it to stand
for two hours if it was transported in a vertical position or 24 hours if transported
in a horizontal position. This is to allow the refrigerant gas to flow back into the
compressor. Failure to comply with this waiting period may damage the compressor.
Sufficient ventilation
•
Make sure that air can always circulate freely around the appliance.
•
To ensure that the appliance can run properly, do not obstruct the vents and leave a space
of at least 20 cm above the appliance, 10 cm between the back and the wall and 2 cm on
each side.
•
If your appliance is to be installed next to another refrigerator or freezer, make sure the
appliances are not touching each other to prevent condensation from forming on the
outside.
Levelling
The appliance must be levelled for vibration-free
operation. . To do this, adjust the height of the front
feet to ensure the appliance is properly balanced.
Climate class
Only install the appliance in a location where the room temperature matches the climate class
for which it was designed (see table below). The climate class is indicated on the rating plate
located on the outside of the appliance.
The table below shows the correct room temperature for each climate class:
Climate class
Room temperature
SN
+10 to +32°C
N
+16 to +32°C
ST
+16 to +38°C
T
+16 to +43°C
See the information on the rating plate to find the climate class of your appliance.
Reversing the opening direction of the doors
You can change the opening direction of your combined refrigerator doors if
necessary.
•
To make these changes, please remove all the shelves from the refrigerator door and follow
the steps below.
