Installation Method Alternatives
Care@Home™ Passive Infrared Detector User Guide
29
Using Screws
The mounting-base has eight holes, as shown in Figure 28 below, to allow for installation flexibility.
Varying combinations of holes allows you to install the PIR either:
Flat on a wall
On an angle facing to the right
On an angle facing to the left
In a corner
The thin plastic covering over the holes can be removed, if necessary. All the corner support holes are
blocked by the mounting-tape. You can drill through the tape, if needed.
Figure 28: Screw Locations in PIR Mounting-Base
Required Equipment
Before beginning, prepare the following equipment:
A drill with a standard appropriate bit
Two 3 X 35 DIN 7982 C screws and dowels – not provided
A standard Philips screwdriver
