ESS InLine 20-Ten Series, Installation And Operation Manual

Page: 20 / 33

IPS Belt Cleaner 20 19/11/2021
SECTION 8 - COMMISSIONING
STEP 1 Ensure that the cleaners are correctly adjusted against the belt as described in
the previous sections.
STEP 2 Ensure that all foreign materials, tools and rubbish have been removed from the
belt and the immediate area.
STEP 3 Start the conveyor, following all appropriate safety start-up procedures.
STEP 4 Observe the action of the cleaner blades. Ensure that there is no vibration in
the blades or mainframe. Ensure that all blades are contacting the belt evenly.
Ensure that there is no marking of the belt surface from the cleaner blades.
Refer to the Trouble Shooting section or contact
ESS if any problems are
observed.
STEP 5 If possible, observe the operation of the cleaner once the belt is loaded.
Observe the cleaning action of the blades. Is the belt clean after the cleaner? If
not, check the cleaner adjustment again, referring to the appropriate tensioner
section. If problems persist, contact
ESS .
STEP 6
Shut down the conveyor. Correct any problems observed. Re-test if necessary.
The cleaner is now ready for production.