Starting up
3.
Filling the water tank
4.
Starting up / Preheating
Note
‧
Never use distilled water.
‧
Use only cold tap water.
‧
After filling the water tank, and before the next time
that coffee is dispensed, press one of the dispensing
buttons, until you obtain a regular flow of water from
the dispenser (without the capsule).
‧
Water which has been softened with
commercially available water filter can be used.
Damages caused by wrong handling of the water filter
are not covered by the guarantee.
‧
If the water tank is empty and the pump sounds very
loud, this does not indicate any malfunctioning. Press
one of the dispensing buttons lit up and the pump is
immediately deactivated.
‧
If no dispensing button is pressed, the pump is
automatically deactivated after 20 seconds.
‧
How does the water level sensor work?
When there is insufficient water in water tank (below
the min. water level), all dispensing buttons will flash
blue alternately in a counterclockwise direction. After
filling the water tank, all dispensing buttons light up in
blue. The machine goes back to normal.
Filling without removing the
tank
‧
Turn off the machine.
‧
Remove the water tank lid.
‧
Fill the tank up to the
MAX
mark with cold water (the
maximum is
1 liter / 1 qt
).
‧
Replace the lid.
Filling by removing the water
tank
‧
Switch off the machine.
‧
Remove the water tank lid.
‧
Lift up the water tank holding
it by the special grip (on the
outside) and remove it pulling
upwards.
‧
Fill the tank up to the
MAX
mark with cold water (the
maximum is
1 liter / 1 qt
).
‧
Lower the water tank into
place, pushing firmly.
‧
Replace the lid.
Connecting the appliance
‧
Connect the machine to a
grounded power point by
plugging in the power plug.
Switching on
Before turning on the power
switch, make sure that:
‧
the operating lever is
closed.
‧
the water tank is full.
‧
the water tank is firmly in
place.
‧
the drip tray with the
container is completely
inserted.
‧
Turn on the machine with the
main power switch.
Preheating
After switching on the
machine the two dispensing
buttons
& flash blue
to indicate heating up.
When heating up is finished
(after approx. 1 min.), all
the four buttons remain
illuminated. The machine is
now ready to use.
Note
Before using for the first time and after long periods of
inactivity (like vacation, e.g.) the internal piping must
be flushed out (for details see:
9. Flushing machine
and internal piping
).