ESPi VOLTAR 2.0 SOLAR UPS
____________________________________________________________________________________
Technical Specifications
10
WIRING INSTRUCTIONS
Figure C – Wiring Instructions
To avoid causing electrical damage to the VOLTAR 2.0 circuit board, please use the
following steps when wiring.
Step 1:
Connect all wires from the VOLTAR 2.0 Output terminal to the load you are
powering. If you have multiple VOLTAR 2.0 units, this should be done for each
unit.
Step 2:
There is 20 feet of red and black photovoltaic wire routed through the enclosure
and connected to the Input 1 terminal. If you do not need to use all 20 feet of
wire, you can shorten to the desired length using the following process.
Disconnect the solar panel to measure the length of wire needed to reach from
the solar panel, through the bottom of the enclosure and up to the Input 1
terminal. Next, loosen the Input 1 terminal screws and cut the red and black
photovoltaic wire to this length. Once this is complete, insert the red and black
photovoltaic wires into the Input 1 terminal and tighten.
Summary of Contents for V2-20A-150W-12V-1D
Page 1: ...USER S MANUAL ...