14 of 52
|
Earth Save Products-ASHP
PASRW030B-D-PS
V 1.8
PASRW040B-D-PS
PASRW050B-D-PS
down. Make sure that the flow and return pipework from/to the
unit have a full flow level valve fitted in-line so that the unit may be
isolated from the complete system before draining it down
– this
avoids the waste of glycol if the whole system were to be drained
down. Make sure that pipework outside is properly lagged so that
it will not freeze in cold weather when the unit is not in use.
Shut off the
power
When cleaning or working on the unit, shut off the power supply.
You MUST
You must use a suitable power supply that is appropriately fused.
IMPORTANT SAFETY INFORMATION FOR THE END USER
− Installation of the heat pump must only be carried out by persons with
suitable engineering qualifications and experience.
− Do not attempt to modify, repair or service the heat pump yourself,
unless you have been appropriately trained and are suitably
qualified.
− Do not insert body parts or any other items into the air inlet or air outlet;
the fans are provided with a guard for good reason!
− Save in emergencies, do not start or stop the unit by switching the power to
the unit on or off; always use the controls provided on the unit/controller.
Starting/stopping the heat pump using mains power is dangerous for you and
may damage the unit.
− Ensure that the heat pump is protected from prolonged exposure to
large quantities of water (e.g. leaking gutters). Failure to do so may
damage the unit.
− Do not operate the unit or the programmer with wet hands/fingers.
− Upon replacement of any fuse in any part of the power feed to the unit,
ensure a correct replacement is used. Do not, under any circumstances,
use a fuse that is too large or bridge the fuse with silver paper, nails,
wire, or anything similar.
− Keep the programmer for the unit out of reach of children.