24
Setting mode
3
Use the setting adjustment (
l
/
;
) buttons to
change the settings.
To change multiple items, repeat steps
2
and
3
.
o
Press the
;
setting adjustment button when “F/W ver.” is
shown to check the versions of other firmware.
Press the
;
setting adjustment button when the FPGA ver-
sion is shown to return to showing F/W ver.
4
Press the INPUT button to end setting mode.
Setting mode will also end and the ordinary display will reappear
if nothing is done for ten or more seconds.
o
Settings are retained even if the power plug is disconnected.
When the remote control AMP button setting
(AMPRM>) is ON
L/R balance (BAL>) and input gain (LVL>) adjustments will not be
shown in MENU 1.
Follow these procedures to change these settings.
o
The buttons in the AMP section on the remote control must be
used (page 17)
1
Press the SETUP button to show the setting to
be changed.
Pressing the SETUP button switches between showing BAL> and
LVL>.
2
Use the INPUT (
l
/
;
) buttons to change the
setting.
3
Press the SETUP button several times to return
to ordinary display and complete the setting.
o
The INPUT button on the unit can also be pressed to com-
plete the setting.
The settings for this unit are divided into three groups: MENU 1,
MENU 2 and MENU 3.
MENU 1, MENU 2 or MENU 3 settings will be shown depending on
how the MENU button is pressed.
Changing settings
1
When stopped or during output, press the
MENU button.
MENU 1 will be shown.
To show MENU 2, press and hold the MENU button.
To show MENU 3, press and hold the
;
setting adjustment but-
ton while gotoMENU3 is shown in MENU 2.
2
Press the MENU button repeatedly to select the
item to change.
Each time you press the MENU button, the item shown on the
display changes as follows.
MENU 1
MENU 2
MENU 3
BAL>
c
LVL>
c
CLK>
c
VOLDP>
c
LOUT>
c
DPaOFF>
c
APS>
PCMF>
c
PCMΔΣ>
c
AFIR>
c
LanLED>
c
NETin>
c
BTstby>
c
F/W ver.
c
gotoMENU3
L_VOL>
c
THRU>
c
MTLV>
c
AMPRM>
c
RS232C>
c
TRIG_O>
o
If you do nothing for ten or more seconds, setting mode will
end and ordinary display will resume.
o
Depending on the selected source and operation status,
some items might not appear.
