Celebrating over 30 years of excellence in manufacturing ultrasonic cleaning
equipment, electropolishing equipment and associated chemistries
ESMA, Inc.
P. O. BOX 734 * SOUTH HOLLAND, IL 60473 * (800)-276-2466 * FAX (708)331-8919
9
7. OPERATION
The basic principle of operation is the enhancement and acceleration of
the cleaning action through ultrasonic cavitations. Instruments, or parts
to be cleaned, are placed in the basket (or cassette racks) and lowered
into the tank.
NEVER PLACE PARTS DIRECTLY ON THE BOTTOM OF THE TANK. The
baskets and cassette racks have rubber supports to keep parts off
bottom of tank.
8. PROCEDURE
1. Turn main power ON
2. Turn RUN-RESET switch to RUN. (Should remain in RUN position at all times.
3. Set FILL/CLEAN/FULL CYCLE switch to FILL.
4. Verify that the metering pump inlet supply is inserted into a gallon jug of an approved Esma cleaning concentrate
(see section on cleaning agents).
5. Lower basket with instruments, or parts, on support rack.
6. Close cover.
7. Push START button and water will enter the tank for 90 seconds.
8. At this point more instruments (or parts) could be added when available, or move FILL/CLEAN/FULL CYCLE
switch to CLEAN, push START button and the cleaning program will automatically proceed through the cycle as
follows: