23
8.
OPERATION MODULE FUNCTIONS
Your EPA 100 process controller runs in two different modes. Your device is in 'operating
mode' while the initial value of the sensor readout is displayed; In the 'programming mode'
on the screen where the settings are changed and the parameters are changed. In this
section, the functions in operating mode are explained.
8.1
TARE FUNCTION
***
Only works when the Tare function is active. For activating or explaining the types of
functions, 7.1.2 Setting the Tare Function
Each time the UP key is pressed while the unit is in operation mode, Tare is activated
according to the type of the selected function and
T
status led lights.
8.2
VIEWING THE MAXIMUM AND MINIMUM READ VALUES
If you press the DOWN key while the unit is in operating mode, you can see the lowest
(minimum) value read from the moment the unit starts to operate.
When you press the DOWN key again, you can see the highest (maximum) value read from
the moment the device starts to operate.
Note: You can use the ESC key to delete the (minimum) and (maximum) values in the
memory.
.
.
.
