Check for parts online at
www.GetEskimo.com
or call
800-345-6007
12
Operator’s Manual
ESKIMO
®
WIDE 1
™
XR Thermal
F I G U R E 1 2
With the skin attached to
the bottom extending tube
assembly
[T]
, align the brackets
on each side with the hole at
the end of each bent aluminum
upright assembly
[Q/R/S]
.
Use one 1/4-20 x 1-3/4 inch
Phillips drive bolt
[#69180]
, two
plastic washers
[#WN516]
, one
1/4 inch washer
[#48261B]
, and
one nut
[#67538B]
to secure
each side.
The two plastic washers
[#WN516]
should be placed
between the tube and the end
brackets to act as a swivel point.
STEP 12
S E E F I G U R E 1 2
Drape the shelter skin over
the top of the frame. Start by
lifting the rear of the shelter skin
over the top of the front frame
support. Make sure that you are
evenly working the shelter skin
over the supports. Continue
working the shelter skin over the
rest of the frame supports until
the shelter skin lies evenly over
the entire shelter.
NOTE: Attaching the skin can be a
difficult task and is easiest with two
people to ensure proper installation
and desired fit.
STEP 13
Once the shelter skin is on the
frame, move to the inside of
the shelter and attach the
hook and loop retainers to
the frame supports.
STEP 14
After attaching all of the hook
and loop retainers, extend the
front bottom pole assembly
[T]
to the “in use” position
(
S E E F I G U R E 1 5
). You are now
ready to install the edge trim
to the rear of the shelter.
Move to the outside of the
shelter and start by identifying
the edge trim piece
[#69654]
from the parts box.
Locate the center of the edge
trim piece by folding it in half.
Line up the center of the edge
trim to the best of your ability
with the center of the rear of
the shelter.
STEP 15
T
Q/R/S
#69180
#WN516
#48261B
#67538B
#WN516
