HANDSET PROGRAMMING
P4
SET UP SYNCHRONIZATION (KY0 and KY4)
1. Once you have fully assembled your desk. It needs to be synchronized at the
lowest position.
2. Ensure there are not obstructions for the desk to move vertically
3. Press and hold the
“UP and DOWN”
arrow buttons at the same time.
4. Continue to hold the
“UP and DOWN”
arrow buttons, the desk will lower until it
reaches the bottom (lowest point).
5. Release the buttons once the system beeps
1. If it does not beep, continue to hold the buttons for 3 seconds after the desk
reaches the lowest point.
6. The system has now been synchronized.
KY0
version is now ready for use.
MEMORY SET POSITIONS (KY4 only)
1. To be performed after “Set up Synchronization”
2. Move the desk to the desired memory position
3. Press and hold the
“UP”
button and memory # button at the same time. (3 to 5
seconds)
4. Display will flash “P#” when programmed
5. For example, pressing
“UP”
and the number 1 for 3 to 5 seconds, the display with
flash “
P1
”
6. Repeat for programming positions 2, 3 and 4.
MOVING TO A MEMORY PRESET POSITION (KY4 HANDSET ONLY)
1. Ensure there are not obstructions for the desk to move vertically
2. Press and hold the memory button #
3. The desk will move to the preset position
NOTE: The memory preset button must be pressed and held with the desk is
moving to the preset position.
KY0
KY4
KY4