Page 5
FlexCharge4
Grommet mount
Desk clamp (option 3)
With this method, the top bracket is turned upside-
down so that it can be mounted to the underside of
the worksurface with M4x14 wood screws. As with the
other methods, the power module is mounted to the
bracket using two M3x12 panhead screws.
Top Bracke
Step #3 attach bracket to underside of worksurface
• Route the power cord through the opening in the top bracket.
• Attach the bracket in the desired location (typically at the front
of the worksurface on the left or right side) using the four M4x14
wood screws. Tighten securely.
M4x14
Top
Bracket
Bottom
Bracket
Clamp
Step #2 remove the desk clamp
• Loosen the M5x8 socket cap screws using the
M4 Allen key.
• Remove the bottom bracket by loosening the
#6-32x1/4” flathead screws using a Phillips
screwdriver
Step #1 drill pilot holes
• Use the top bracket as a template to mark where to drill four
pilot holes.
Drill 0.5” deep pilot holes using a 0.125” drill bit.
Caution: Be careful not to not drill through the top of the worksurface.
#6-32x1/4
top bracket
bottom
bracket
clamp
M5x8
top bracket
