Hardware Installation
Page 18 of 28
Hardware Manual Doc.-Nr.: E.1108.21 /Rev. 1.0
ECS-CPCIs/FPGA
3 Hardware Installation
NOTICE
Read the safety instructions at the beginning of this document carefully before
you start with the hardware installation!
WARNING
Hazardous Voltage -
Risk of electric shock
due to unintentional contact with
uninsulated live parts with high voltages inside of the system into which the ECS-
CPCIs/FPGA is to be integrated.
→
→
Disconnect all hazardous voltages (mains voltage) before opening the system.
Ensure the absence of voltage before starting any electrical work.
NOTICE
Electrostatic discharges may cause damage to electronic components.
→
→
To avoid this, please discharge the static electricity from your body
before
you touch
the ECS-CPCIs/FPGA.
Furthermore, you should prevent your clothes from touching the ECS-CPCIs/FPGA,
because your clothes might be electrostatically charged as well.
Procedure:
1.
Switch off your system and all connected peripheral devices (monitor, printer, etc.).
2.
Discharge your body as described above.
3.
Disconnect the system from the mains.
Make sure that no risk arises from the system into which the ECS-CPCIs/FPGA shall be
inserted.
DANGER
Hazardous Voltage
Risk of electric shock
due to unintentional contact with uninsulated live parts with
high voltages.
→
→
→
→
Disconnect all hazardous voltages (mains voltage) before opening the system.
If the system does not have a flexible mains cable, but is directly connected to
mains, disconnect the power supply via the safety fuse and make sure that the fuse
cannot switch on again unintentionally (with caution label e.g.).
Ensure the absence of voltage before starting any electrical work.
Cover or block off adjacent live parts.
4.
Open the case if necessary.
5.
Insert the ECS-CPCIs/FPGA board into the selected CompactPCI Serial slot. Carefully push
the board down until it snaps into place. If applicable secure the front panel in place with the
screw.
6.
Close the system's case again.
7.
Connect the EtherCAT interfaces via the connectors in the front panel of the ECS-
CPCIs/FPGA.
8.
Connect the system to mains again (mains connector or safety fuse).
9.
Switch on the system and the peripheral devices.
13. End of hardware installation.
14. Set the interface properties in your operating system. Refer to the documentation of the
operating system.
