EtherCAT Communication
Webserver Interface, see chapter 6.
(As Ethernet–EtherCAT forwarding is still active this configuration should match the LAN settings
the EtherCAT network is in, i.e. no duplicate IP addresses must exist, etc.)
5.2.4 Disabling EoE
The CAN-EtherCAT reads the “EoE enabled” bit from its EEPROM (cat. “General”, as defined in
ETG.1000.6 documents). When this is set to 0 (checked at first change to PreOp after device start
up), all EoE activity will be disabled and all EoE configuration options are ignored.
Figure 28:
esd EtherCAT Workbench: Where to en/disable EoE
CAN-EtherCAT
Manual • Doc. No.: C.2922.21 / Rev. 1.4
Page 53 of 92
