M
set
Make sure that the electrical parameters of the device correspond to the parameters of the
controller (maximum voltage, current rating, power).
Diagram of connecting the receiving device:
11.CONNECTION OF RECEIVING DEVICES
12. FACTORY SETTINGS.
If you forgot you password to the configuration menu or the timer after a power failure or a short
circuit displays
memory error
you can restore default parameter settings:
Turn off the timer.Then
press both buttons
, at one time and
switch the power supply
on holding the buttons..
Command:
clear” displays.
Command disappears
after 5 seconds and four
horizontal pointers
display. Then release the
buttons and the controller
restores factory settings
and goes into normal
operation mode .
M
set
8
Timer meets the requirements for immunity to electromagnetic interference in an industrial
environment according to the following standards:
Electromagnetic compatibility (EMC):
–EN-61000 part 6-4 – requirements for emissivity in an industrial environment
–EN-61000 part 6-2 – requirements for immunity in an industrial environment
It also meets the safety requirements according to standard:
–EN-61000 part 1 – safety requirements for eletrical devices
Controller meets the requirements of EU directives No. 72/23/EEC; 93/68/EEC; 89/336EEC.
13. ADMiSSIONS.
20(8)A 250VAC
Power
230VAC
Power supply
230VAC
Input D1
START/STOP
TC-11
7
12
6
Receiving device
N
N
L
L
L
11
10
9
N
5
4
Input D2
RESET
3
2
